Non air bag equipped:
|
|
| Remove three 1/4 turn screws along top edge of panel and one below the
steering column |
 |
| Pull panel forward and out. Remove chime module from bracket in panel by
pulling back tabs. |
 |
NOTE: Steering wheel has been removed for clarity of photographs.
It is not necessary to remove the steering wheel to remove the cluster
|
|
| Remove two knurled nuts from the rear of the plastic cover between the
instruments and the steering column, one on each side. |
 |
| Remove two small Phillips screws from top of cluster surround, two small
silver Phillips screws on either side of the steering column and two long Phillips screws,
located one each side of the lower edge of the surround |
 |
| CAUTION:
Mixing up the screws along the lower edge of the surround will result in damage to
the battery board. Maximum length of two inner screws, by steering column, is 9.5mm |
 |
| Remove surround and remove two small Phillips screws from upper brackets
on cluster. |
 |
| Gently pull down upper cluster brackets to clear dash top and slide
cluster forward at the top. |
 |
| Pull cluster as far forward as possible, reach behind it and disconnect
wiring connectors. There are 3 main wiring plugs, white, blue and yellow. Check
engine light and ABS lights are separate light bulbs, with two wires, for each. These pull
straight out of the socket.
Cruise control adds another, single wire connector to the rear of the speedometer (blue
arrow). |
 |
| Each main connector has a black tab in the center. Lift this black tab
straight up, away from the connector to release. When tab is at full extent, pull plug
from cluster. |
 |
|
|
Installation:
|
|
| Install wiring connectors with black tab fully extended. Seat connector
then push tab in to lock. |
 |
| Cruise control speed signal wire can go in any of three compatible spaces
in the green connector on the rear of the speedometer. |
 |
| If the vehicle does not have cruise, it may not have the green adapter on
the rear of the cluster. |
 |
Blue and white connectors (green arrows) are present on all clusters.
Yellow connector (pink arrow) is not used if there is no tachometer.
Orange arrow is ABS light, if equipped
Red arrow is Check Engine light, if equipped
Blue arrow is cruise control speed signal, if equipped. |
|
| Ensure rear edge of panel locates correctly in bracket on steering
column. |
 |
