NOTE: It is possible to dismount the thigh
bolster from the seat, but the material covering the thigh bolster is one piece with the
seat base and cannot be detached.
|
| Move seats fully rearward, remove caps from nuts and remove the 17mm nut
from front of each rail. |
 |
| Move seats fully forward and remove the two 17mm bolts from rear of rails. |
 |
| Disconnect seatbelt switch wiring from below drivers seat |
 |
| Lift seats out of car carefully to avoid damaging paint or trim. |
|
| Turn seat upside down, move thigh bolster to a position where clip can be
removed. |
 |
| Remove clip and pivot pin. |
 |
| Slide bolster off front of seat. Note, bolster is attached to seat
base by upholstery. |
 |
| Pry back the two tabs on each end of bolster and pull upholstery over
them. |
 |
| Pull channel off front and rear of bolster. |
 |
| Remove metal support and foam. |
 |
