Non air bag equipped:
|
|
| Remove three 1/4 turn screws along top edge of panel and one below the
steering column |
 |
| Pull panel forward and out. Remove chime module from bracket in panel by
pulling back tabs. |
 |
Air bag equipped:
|
|
| Remove the four 7 mm hex head screws from bottom edge of trim panel. |
 |
Remove the three Phillips screws securing trim panel to dash.
Remove trim panel. |
 |
| Pull horizontal panel down and forward. Remove chime module wiring
connectors or entire module by spreading the plastic clips securing it to the panel. |
 |
| If necessary, remove the knee bolster by removing two 10mm bolts on left
and three 10mm bolts on right side of bolster. |
 |
Installation:
|
|
Non air bag equipped:
|
|
| Ensure rear edge of panel locates correctly in bracket on steering
column. |
 |
Air bag equipped:
|
|
Mount bolster first.
|
|
| Ensure rear edge of horizontal panel seats in clip on center console. |
 |
| Loosely insert the four 7 mm hex head screws through
horizontal panel into bolster. |
| Trim panel is slotted on bottom edge to allow it to be inserted past the
screws. Line up trim panel and install screws along upper edge first, tightening the
hex screws along bottom edge last. |
 |
