| Drivers door: Gently pry out mirror switch and
disconnect. |
 |
| Passenger door: Pry out plastic cover from armrest. |
 |
| Remove screw in opening. |
 |
| Remove 2 screws in bottom of armrest. |
 |
| Slide armrest forward to disengage clip from storage compartment, remove
armrest. Follow green arrows to remove and white arrows to install |
 |
| Pry inner door handle surround towards rear of car, and lift off door
panel |
 |
| If door lock button has a knob on top, unscrew it |
 |
| Use a trim tool or gently use a flat screwdriver to pop door panel clips
from door, start at the lower front corner where damage will be less noticeable if you
make a mistake. |
 |
| Once clips are disengaged on bottom and sides of panel, lift
panel straight up. Window seal may come out with panel. |
| If seal does not come out with panel, gently pry upwards on last two
clips, grab seal and pull out of remaining clips. |
 |
Installation:
|
|
| Align door lock rod with hole in door panel. |
 |
| Position window seal on door, not panel, replace any damaged clips. Seal
clips go over dimples in sheet metal. |
 |
| Replace any damaged door panel or seal clips. |
|
