| Drivers door: Gently pry out mirror switch and
disconnect. |
 |
| Passenger door: Pry out plastic cover from armrest. |
 |
| Remove screw in opening. |
 |
| Remove 2 screws in bottom of armrest. |
 |
| Slide armrest forward to disengage clip from storage compartment, remove
armrest. Follow green arrows to remove and white arrows to install |
 |
| Lower window, dead electric motors can be over ridden (on earlier cars)
with the Allen key from the tool kit, remove plug from door panel. |
 |
| Remove rubber plug from window motor. |
 |
| Insert Allen key crank handle and wind window down. |
 |
| Pry inner door handle surround towards rear of car, and lift off door
panel |
 |
| If door lock button has a knob on top, unscrew it |
 |
| Use a trim tool or gently use a flat screwdriver to pop door panel clips
from door, start at the lower front corner where damage will be less noticeable if you
make a mistake. |
 |
| Once clips are disengaged on bottom and sides of panel, lift
panel straight up. Window seal may come out with panel. |
| Peel plastic splash sheet up from lower front corner |
 |
| Pull back rubber cover from hinge on pillar. |
 |
| Remove clip from bottom of hinge pin and drive pin up and out. |
 |
CAUTION: Door becomes very loose and can swing shut, beware of damage to pillar from door
stop rod once pin is removed.
|
| Remove two 10mm nuts securing door stop to door frame. |
 |
Installation:
|
|
| Door stop fits both doors. |
|
| Align door lock rod with hole in door panel. |
 |
| Position window seal on door, not panel, replace any damaged clips.
Clips go over dimples in sheet metal. |
 |
| Replace any damaged door panel clips. |
|
