Park brake handle mechanism, remove and install.
| Pull boot off park brake handle by raising the front edge,
then pulling forward. |
 |
| Remove both adjusting nuts on cable ends. Pull cables
out of handle. |
 |
CAUTION : Hold squared off section (green arrow
above) of cable with pliers or it is possible to twist the end off the cable while trying
to undo the adjusting nuts. If cable end breaks off, cable must be replaced.
|
| Press down copper spring tab and remove wire from park brake switch (blue
arrow). Remove three 13mm bolts (green arrows) from park brake assembly.
(Seats removed for clarity of photograph) |
 |
 |
|
